Leaking gas line repair
The leak is pinpointed, the section is replaced, and the line is pressure-tested.
If you smell gas or hear hissing near a line or appliance, leave the area now. PG&E's guidance is to leave and call 911 from a safe distance.
Signs of a gas leak, from PG&E: a rotten-egg smell; hissing, whistling or roaring sounds; and damaged connections to gas appliances.
Our gas piping services in Clovis, CA start with the same question: what will it feed, and how much gas does it need? Pick your project.
Your gas system runs in one direction: from the PG&E meter, through the house line, to a shutoff at each appliance. A new line ties into this system, so it has to be sized for everything on it.
Sizing matters in any residential gas line installation. A line that's too small can starve an appliance when everything runs at once. That's why a tankless heater or pool heater often needs a larger gas pipe installation.
Gas line repair starts once everyone is safe and PG&E or the fire department has cleared the scene. Then the damaged section is found, repaired and pressure-tested.
Three rules shape most gas line projects in Clovis. Each one protects you, your neighbors and the buried lines under your yard.
New gas piping usually needs a permit and an inspection before the gas is turned on. Check with the City of Clovis building department for your project. In Tarpey Village, check with Fresno County.
California Government Code section 4216.2 covers digging near buried utilities. Except in an emergency, an excavator must notify 811 at least two working days, and no more than 14 calendar days, before digging. That covers trenching for an outdoor gas line.
California's Carbon Monoxide Poisoning Prevention Act requires CO alarms in single-family homes with a fossil fuel appliance, a fireplace or an attached garage. Adding a gas appliance is a good time to check yours work.
This is general information, not legal advice.
Call (559) 418-4780. Tell us what the line will feed and where it needs to go.
Site visit and sizing. The plumber checks your meter, existing lines and every gas appliance on the system.
Written scope. Route, pipe type, permit and cost are set out before work starts.
Install and test. The line is run, connected and pressure-tested.
Inspection and hookup. Where a permit applies, the line is inspected, then the appliance is connected and checked.
Arrival time depends on where you are in Clovis, traffic and the jobs already underway. You'll get a realistic time when you call.
We install and repair the gas piping. We don't repair the appliances on the end of it.
A good gas line contractor in Clovis, CA sizes the line for your whole system, not just the new appliance. Look for these:
There is no fixed price for gas line installation or repair. Cost is set after the job is assessed. It depends on:
If a gas line problem damaged your property, we can provide photos, the cause we found and a record of the repair. You can submit these documents to your insurance company to request compensation. Whether a loss is covered is between you and your insurer. We don't make coverage decisions or promise any outcome.
We install and repair gas lines across Clovis and Tarpey Village. Pick your area for local details.