Galvanized steel
Dull gray metal with threaded joints. A magnet sticks to it.
Rusts from the inside, narrows the pipe and drops pressure.
Plan a galvanized pipe replacement.
One leak is a repair. A house that keeps leaking, runs rusty or loses pressure everywhere is telling you the pipes are worn out. Tick what you've noticed:
Ticked 3 or more? Your pipes may be wearing out. Call (559) 418-4780 and ask about residential repiping.
Look under a sink or at the pipes going into your water heater. The material tells you a lot about what's coming.
Not sure what you have? Call (559) 418-4780 and describe it. We'll tell you what it likely is.
Both PEX repiping and copper repiping can last for decades when installed well. PEX pipe installation is quicker through finished walls. Copper is rigid metal that many owners prefer for exposed runs.
116.4 ppm · average hardness, 2023
0.17 ppm · copper at the 90th percentile, against a 1.3 ppm action level (2021 sampling)
Clovis water is hard, and that mineral load builds scale inside older metal pipes. The City of Clovis 2023 water quality report lists average hardness of 116.4 ppm, ranging up to 280 ppm.
The same report shows lead was not detected at the 90th percentile, and none of the 53 sites sampled in 2021 exceeded the lead or copper action levels. The City notes that lead mainly comes from service lines and home plumbing. If water has sat for several hours, it advises running the tap for 30 seconds to 2 minutes before drinking or cooking.
Repair the pipe when the problem is in one place. Repipe when the leaks, rust or low pressure show up all over the house.
A burst pipe is an emergency. Close the main shut-off valve now, then call (559) 418-4780. We take emergency pipe repair calls 24 hours a day for broken water pipes, burst water lines and cracked pipes.
Arrival time depends on where you are in Clovis, traffic and the jobs already underway. You'll get a realistic time when you call.
Our home repiping services are planned room by room, so you know what happens and when before the first wall is opened.
Walkthrough. The plumber maps every fixture, the water heater and the main line, then explains the plan.
Written scope. You get the pipe material, the rooms involved, the timeline and the cost in writing.
Protect the home. Floors and furniture near each work area are covered.
Small access openings. Walls are opened only where the new lines need to pass.
New lines and switch-over. New pipe is run, then each fixture is switched to it. You're told when the water will be off.
Pressure test and inspection. The system is tested for leaks and inspected where a permit applies.
The overall timeline depends on the size of the house and the number of fixtures. You get it in writing before work starts.
We replace the pipes and make the openings needed to reach them. Finishing the walls afterward is a separate trade.
A good repiping company in Clovis, CA shows you why the pipes need replacing before quoting a repipe. Look for these:
There is no fixed price to repipe a house in Clovis, CA or to repair a single pipe. Cost is set after the job is assessed. It depends on:
If a burst or leaking pipe damaged your home, we can provide photos, the failed section of pipe, the cause we found and a record of the repair. You can submit these documents to your insurance company to request compensation. Whether a loss is covered is between you and your insurer. We don't make coverage decisions or promise any outcome.
We repipe homes across Clovis and Tarpey Village. Older homes, such as those in Old Town Clovis, are more likely to have older pipe materials.